Installation
Add your application by wizard
You can add your application via the integration wizard, you can find the button for this on the dashboard page.
After pressing the the start integrating button a pop up will appear with the wizard, please make sure you do not use any pop-up blocker at this point.
Press next and in the following screen you can add your applications that you want to connect. fill out the required information per app, authorize and test and then both applications are in your wizard available.
For "Bol.com" the following fields need to be filled out for a successful connection to be established.
- Display Title: The name of the application, no special requirements.
- This can be useful if there are multiple Bol.com applications, to be able to distinguish between them.
- Client ID: The Client ID for the Webservice App, which allows access to the API.
- Check the section below on how to find this parameter.
- Client Secret: The Client Secret for the Webservice App, which allows access to the API.
- Check the section below on how to find this parameter.
Bol.com settings location
Client ID and Client Secret
To find these parameters, a Webservice App must be available or created, please follow the next few steps.
- Login to the Bol.com Seller portal and open the settings section.
- Navigate to the API Settings.
- Scroll down til you find the "Client credentials voor de Retailer API header". Now, create a new API Key, or use an existing one. Warning, only one set of ID/Secret can be used at one time. So make sure no other third-party application is using the same credentials.
- Copy the API-keyand API-secret into Client ID and Client Secret respectively.
- When settings are filled out, the result installation form should look something like this.
In step 3 you can select the packages that you want to make use of. These packages are the flows that determine what data is send from and to AccountView.
In step 4 you can set the all the settings that tweaks your integration without adjusting mappings and or adjusting code. In this step you need to do this for all your flows. The settings we have standard enabled and disabled are based upon 90% of the integrations we currently have running.
Step 5 finishes the wizard and on this point you can enable the flows to start running, if you want to adjust advanced settings we advice to start them manually in the integrations overview.